First of all, you need to set up the surface preparation. Tile can be set up on plywood or concrete. It should consist of a firm and level surface area. Concrete must be set up with mortar right before setting the tile. Should you set up tile on a wallboard or sub-floor set them with the nails first. If you have an uneven surface, protect it with 3/8 inches thick of plywood.
The laying of the first low of tiles is very essential. If for instance you are setting up tile over a wall around the bathtub, you can draw a line just as tall as the tiles over the rim of the bathtub over the rim. Put in tacks that have a chalked string on every end of the line. Be sure that the line is leveled and use a string to draw a chalked line. Have the width of your tiles marked with the yardstick.
After you are done marking the width of the tiles, mark with the vertical chalk line using the yardstick for accurate measurements. Spread adhesives with one of the vertical lines. Spread the adhesive with a notch edge towel. Gently apply over the tiles starting from the bottom to the top. Once this is done with the whole pieces, you may then follow up with the smaller pieces.
Cutting fractional tile pieces is the next step. With the use of China marking pencil, set a line above the tile. This will enable you to cut the tile by having a pencil or nail underneath or breaking it in two.
Wait for at least two days for the adhesive to be good before setting up the grouting. Utilize damp sponge to wipe away the tiles. Wipe out the extra adhesive. Wait until the next day and fill in the joints inside the grout. This is a very tedious procedure and it would be much better to hire an exterminator professional and yield the best results.
No comments:
Post a Comment